Applies to all radio remote controls Flex HANDY
Before pairing, check that the LED indication of both transmitters shows normal status. The STATUS LED must turn green for about 1 second after switching on and then turn off.
When pairing, both transmitters must be close together (5 cm max).
Switch both transmitters to service mode
Remove the batteries from the transmitters and move the DIP #8 of DIP-switch under the batteries to the ON position – see picture below.
Insert the batteries and switch on both transmitters by releasing the STOP button. The STATUS LED will flash differently when switched on.
Follow this procedure for both transmitters.
Transfer of setting
Transmitters in pairing mode close together, press PB2 on the old transmitter (left) and PB1 on the new one (right) – see picture below.
The STATUS LED on the new transmitter (right) will flash green rapidly at first and will remain green when pairing is complete.
Should it fail the first time, release the buttons and press them again after about a second.
When you have finished, switch off both transmitters, DIP #8 in both transmitters turn back to OFF and set the other DIP-switches of the new transmitter (DIP 7 and 8 must always be OFF) according to the old transmitter.
Test all functions.
If you accidentally change the transmitters, they will both be useless and you have to pair them according to the receiver.
If you have any questions, please contact us at any time at service TER CESKA.